Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 311)

Specifies the action to take when the error count exceeds the specified threshold and log
back-off values.
none
No action is taken. This is the default action.
syslog
The error is logged to syslog.
Modes Global configuration mode.
Usage Guidelines This is a global configuration for all packet processors-- you cannot configure sysmon parameters for
individual packet processors. However, you can display the logs for individual packet processors by
specifying the packet processor identifier.
This command is supported only on FSX devices.
Examples The following example configures system monitoring on packet processors:
Brocade(config)# sysmon pp error-count threshold 3 7
Brocade(config)# sysmon pp error-count action syslog
Brocade(config)# sysmon pp error-count log-backoff 15
clear sysmon counters
Clears sysmon counters for all or specific event types.
Syntax clear sysmon counters all
clear sysmon counters fa { error | link } { all | decimal }
clear sysmon counters pp error { all | decimal }
clear sysmon counters xbar { error | link } { all | decimal }
clear sysmon counters { ecc-error | link-error }
Parameters all
Clears all sysmon counters.
fa
Clears the fabric adaptor sysmon counters.
error
Clears the fabric adaptor error counters. You can specify all or a fabric adaptor,
identified by the index.
link
Clears the fabric adaptor sysmon counters for links. You can specify all or a fabric
adaptor identified by the index.
pp error
Clears packet processor sysmon counters. You can specify all or a packet processor
identified by the index.
clear sysmon counters
FastIron Ethernet Switch Administration Guide 311
53-1003075-02