Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 330)

Message DOT1X: port portnum - MAC mac address Port is
already bound with MAC filter
Explanation The RADIUS server returned a MAC address filter, but a MAC address
filter had already been applied to the port.
Message Level Informational
Message DOT1X:port portnum - MAC mac address This device
doesn't support ACL with MAC Filtering on the
same port
Explanation The RADIUS server returned a MAC address filter while an IP ACL was
applied to the port, or returned an IP ACL while a MAC address filter was
applied to the port.
Message Level Informational
Message DOT1X: Port portnum is unauthorized because
system resource is not enough or the invalid
information to set the dynamic assigned IP ACLs
or MAC address filters
Explanation 802.1X authentication could not take place on the port. This happened
because strict security mode was enabled and one of the following
occurred:
• Insufficient system resources were available on the device to apply an IP
ACL or MAC address filter to the port
• Invalid information was received from the RADIUS server (for example,
the Filter-ID attribute did not refer to an existing IP ACL or MAC address
filter)
Message
Level Informational
Message DOT1X: Port portnum currently used vlan-id
changes to vlan-id due to dot1x-RADIUS vlan
assignment
Explanation A user has completed 802.1X authentication. The profile received from the
RADIUS server specifies a VLAN ID for the user. The port to which the
user is connected has been moved to the VLAN indicated by vlan-id .
Message Level Informational
Message DOT1X: Port portnum currently used vlan-id is set
back to port default vlan-id vlan-id
Syslog messages
330 FastIron Ethernet Switch Administration Guide
53-1003075-02