beautypg.com

Clearing the syslog messages from the local buffer, Syslog messages for hardware errors – Brocade FastIron Ethernet Switch Administration Guide User Manual

Page 227

background image

Syntax: [no] logging persistence

Enter no logging persistence to disable this feature after it has been enabled.

Clearing the Syslog messages from the local buffer

To clear the Syslog messages stored in the local buffer of the Brocade device, enter the clear logging
command.

device#clear logging

Syntax: clear logging

Syslog messages for hardware errors

NOTE
This feature is supported on FastIron X Series devices only. It is not supported on FCX and ICX
devices.

FastIron Chassis devices support the display of hardware read and write errors encountered on a slot or
module during bootup and during normal system operations. There are four types of errors, which may
cause the system to disable or power down the modules on which they occur:

• Configuration read error
• Configuration write error
• Memory read error
• Memory write error

The following shows examples of some hardware errors in the show logging display output.

device>#show logging

Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)

Buffer logging: level ACDMEINW, 3 messages logged

level code: A=alert C=critical D=debugging M=emergency E=error

I=informational N=notification W=warning

Dynamic Log Buffer (50 lines):

0d00h00m27s:I:System: Interface ethernet mgmt1, state up

0d00h00m26s:N:powered On switch Fabric

0d00h00m17s:N:powered On switch Fabric

0d00h00m08s:I:System: Warm start

0d00h00m08s:I:SNMP: read-only community added by from session

0d00h00m02s:A:System: Module in slot 5 encountered unrecoverable PCI bridge

validation failure. Module will be deleted.

0d00h00m02s:A:System: Module in slot 5 encountered unrecoverable PCI config read

failure. Module will be deleted.

0d00h00m02s:A:System: Module in slot 5 encountered PCI config read error: Bus 10, Dev

3, Reg Offset 0.

0d00h00m00s:W:System: Fan speed changed automatically to 1

Syslog messages (alerts) for hardware errors are listed in

Brocade Syslog messages

on page 319.

Clearing the Syslog messages from the local buffer

FastIron Ethernet Switch Administration Guide

227

53-1003075-02