Basic system parameter configuration – Brocade FastIron Ethernet Switch Administration Guide User Manual

Page 30

Feature

ICX 6430

ICX 6450

FCX

ICX 6610

ICX 6650

FSX 800
FSX 1600

ICX 7750

10/100/1000 port speed

08.0.01

08.0.10

Auto-negotiation

08.0.01

08.0.10

Auto-negotiation maximum port speed
advertisement and down-shift

08.0.01

08.0.10

Duplex mode

08.0.01

08.0.10

Auto MDI/MDIX detection

08.0.01

08.0.10

Port status (enable or disable)

08.0.01

08.0.10

Flow control: Responds to flow control
packets, but does not generate them

08.0.01

08.0.10

Symmetric flow control: Can transmit
and receive 802.3x PAUSE frames

08.0.01

08.0.10

Auto-negotiation and advertisement of
flow control

08.0.01

008.0.10

PHY FIFO Rx and TX Depth

08.0.01

Interpacket Gap (IPG) adjustment

08.0.01

08.0.10

CLI support for 100BaseTX and
100BaseFX

08.0.01

Gbps fiber negotiate mode

08.0.01

08.0.10

QoS priority

08.0.01

08.0.10

VoIP auto-configuration and CDP

08.0.01

08.0.10

Port flap dampening

08.0.01

08.0.10

Port loop detection

08.0.01

08.0.10

Basic system parameter configuration

Brocade devices are configured at the factory with default parameters that allow you to begin using the
basic features of the system immediately. However, many of the advanced features such as VLANs or
routing protocols for the device must first be enabled at the system (global) level before they can be
configured. If you use the Command Line Interface (CLI) to configure system parameters, you can find
these system level parameters at the Global CONFIG level of the CLI.

NOTE
Before assigning or modifying any router parameters, you must assign the IP subnet (interface)
addresses for each port.

For 100BaseTX. ICX 6430-C supports 100BaseFX.

For 100BaseTX.

Basic system parameter configuration

FastIron Ethernet Switch Administration Guide

53-1003075-02