Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 306)

polling-interval
Specifies the number of polling windows. The device polls the internal registers at the
interval specified by the sysmon timer value. Valid values 1-32. However, the polling
window number must be equal or greater than the number of events.
log-backoff
If an error condition persists, it will be continuously logged (internally and/or externally to
syslog as defined by the action). The log back-off count skips configured number of logs
before logging again.
action
Specifies the action to take when a fabric adapter error count exceeds the specified
threshold and log back-off values.
none
The error is logged in the internal sysmon logs. This is the default value.
syslog
The error is logged to syslog.
Modes Global configuration mode.
Usage Guidelines This command is supported only on FSX devices.
Examples The following example configures system monitoring for fabric adaptor errors:
Brocade(config)# sysmon fa error-count threshold 3 7
Brocade(config)# sysmon fa error-count action syslog
Brocade(config)# sysmon fa error-count log-backoff 15
sysmon fa link
Configures system monitoring for link errors on all or specified fabric adaptors. The no form of this
command resets the parameters to default values.
Syntax sysmon fa link { threshold events polling-interval | log-backoff value | action { none | syslog } }
no sysmon fa link
Parameters threshold
Defines the failure threshold for the fabric adapter link error event. The threshold is defined
as N/W, where N is the number of events, and W is the number of consecutive polling
periods. When the threshold is reached, actions configured for this event type will take
place. Note that a threshold of 1/W implies that there is no threshold, and no event will be
triggered.
events
Specifies the threshold in terms of the number of events. Valid values are 1 through
10.
polling-interval
sysmon fa link
306 FastIron Ethernet Switch Administration Guide
53-1003075-02