Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 239)

0 output errors, 0 collisions
Relay Agent Information option: Disabled
Egress queues:
Queue counters Queued packets Dropped Packets
0 0 0
1 0 0
2 0 0
3 0 0
4 0 0
5 0 0
6 0 0
7 0 0
Clearing the egress queue counters
You can clear egress queue statistics (reset them to zero), using the clear statistics and clear
statistics ethernet port command.
Syntax: clear statistics [ ethernet port]
Specify the port variable in the format stack-unit/slotnum/portnum.
RMON support
The Brocade RMON agent supports the following groups. The group numbers come from the RMON
specification (RFC 1757):
NOTE
RFC 1757 is obsolete and is replaced by RFC 2819 for the Brocade ICX devices.
• Statistics (RMON Group 1)
• History (RMON Group 2)
• Alarms (RMON Group 3)
• Events (RMON Group 9)
The CLI allows you to make configuration changes to the control data for these groups, but you need a
separate RMON application to view and display the data graphically.
Maximum number of entries allowed in the RMON control table
You can specify the maximum number of entries allowed in the RMON control table, including alarms,
history, and events. The default number of RMON entries allowed in the RMON control table is 2048 on
the FSX 800 and FSX 1600. The maximum number of RMON entries supported is 32768.
To set the maximum number of allowable entries to 3000 in the RMON history table, enter commands
such as the following.
device(config)#system-max rmon-entries 3000
device(config)#write mem
device(config)#exit
device#reload
Clearing the egress queue counters
FastIron Ethernet Switch Administration Guide 239
53-1003075-02