Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 236)

The vlan-ID parameter identifies the VLAN ID for which outbound traffic will be counted. Enter a
number from 0 - 4095 or enter all to indicate all VLANs.
The priority-queue parameter identifies the 802.1p priority queue for which traffic will be counted. Enter
a number from 0 - 7 or enter all to indicate all priority queues.
Displaying enhanced traffic counter profiles
To display the details of the traffic counters configured on your device, enter the show transmit-
counter profiles command. The following shows an example output.
device#show transmit-counter profiles
Tx Counter Port(s) Vlan Id Priority Device Set
1 1 - 12 All All Dev 0 Set0
4 18 1 7 Dev 1 Set0
10 13 - 24 100 All Dev 1 Set1
Displaying enhanced traffic counter statistics
To display the traffic counters for outbound traffic, enter the show transmit-counter profiles
command.
NOTE
Once the enhanced traffic counters are displayed, the counters are cleared (reset to zero).
The following shows an example output.
device#show transmit-counter values 1
Transmit Queue Counter Values for Counter 1:
Transmitted Frames:
Known Unicast : 17204
Multicast & Unknown Unicast : 2797
Broadcast : 5
Dropped Frames:
Bridge Egress Filtered : 2
Congestion Drops : 0
device#show transmit-counter values 4
Transmit Queue Counter Values for Counter 4:
Transmitted Frames:
Known Unicast : 124
Multicast & Unknown Unicast : 2752
Broadcast : 0
Dropped Frames:
Bridge Egress Filtered : 37
Congestion Drops : 0
Syntax: show transmit-counter values number
where number identifies a valid enhanced traffic counter and is a value from 1 - 64.
Outbound traffic counter statistics TABLE 33
This line... Displays...
Transmitted frames
Known Unicast The number of known unicast packets transmitted.
Multicast & Unknown
Unicast The number of multicast and unknown unicast packets transmitted.
Displaying enhanced traffic counter profiles
236 FastIron Ethernet Switch Administration Guide
53-1003075-02