Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 296)

inline power
Configures inline power on PoE ports.
Configures inline power on Power over Ethernet (PoE) ports in interface configuration mode and link
aggregation group (LAG) secondary ports in global configuration mode.
Syntax [no] inline power ethernet interface [ decouple-datalink ] [ power-by-class power-class ] [ power-
limit power-limit ] [ priority priority -value ]
Interface configuration mode syntax
[no] inline power [ decouple-datalink ] [ power-by-class power-class ] [ power-limit power-limit ] [
priority priority -value ]
Parameters ethernet
Specifies an Ethernet interface. You can configure the ethernet keyword only in global
configuration mode.
interface
Specifies the interface number.
decouple-datalink
Specifies decoupling of datalink and PoE so that datalink state changes do not affect the
PoE state. You can configure the
decouple-datalink keyword in global and interface
configuration modes.
power-by-class
Specifies the power limit based on class value. The range is 0-4. The default is 0.
power-limit
Specifies the power limit based on actual power value in mW. The range is 1000-15400|
30000mW. The default is 15400|30000mW.
priority
Specifies the priority for power management. The range is 1 (highest) to 3 (lowest). The
default is 3.
Modes Global configuration mode
Interface configuration mode
Usage Guidelines You cannot configure inline power on PoE LAG ports in interface configuration mode because the
interface-level configuration is not available in the CLI for LAG secondary ports. The inline power
ethernet command allows you to configure inline power on secondary ports in global configuration
mode.
The decouple-datalink keyword was introduced in Release 08.0.01 to support the inline-power
functionality. The decouple-datalink functionality is not supported in releases earlier than Release
08.0.01.
inline power
296 FastIron Ethernet Switch Administration Guide
53-1003075-02