Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 187)

The power-via-MDI advertisement will appear similar to the following on the remote device, and in the
CLI display output on the Brocade device (show lldp local-info ).
+ 802.3 Power via MDI: PSE port, power enabled, class 0
Power Pair : A (not controllable)
Syntax:[no] lldp advertise power-via-mdi ports ethernet port-list | all
LLDP-MED configuration
This section provides the details for configuring LLDP-MED.
The following table lists the global and interface-level tasks and the default behavior/value for each task.
LLDP-MED configuration tasks and default behavior / value TABLE 22
Task Default behavior / value
Global CONFIG-level tasks
Enabling LLDP-MED on a global basis Disabled
Enabling SNMP notifications and Syslog
messages for LLDP-MED topology change Disabled
Changing the Fast Start Repeat Count The system automatically sets the fast start repeat count to 3 when a
Network Connectivity Device receives an LLDP packet from an
Endpoint that is newly connected to the network.
NOTE
The LLDP-MED fast start mechanism is only intended to run on links
between Network Connectivity devices and Endpoint devices. It does
not apply to links between LAN infrastructure elements, including
between Network Connectivity devices, or to other types of links.
Interface-level tasks
Defining a location ID Not configured
Defining a network policy Not configured
Enabling LLDP-MED
When LLDP is enabled globally, LLDP-MED is enabled if the LLDP-MED capabilities TLV is also
enabled. By default, the LLDP-MED capabilities TLV is automatically enabled. To enable LLDP, refer to
Enabling and disabling LLDP on page 174.
NOTE
LLDP-MED is not enabled on ports where the LLDP operating mode is receive only or transmit only.
LLDP-MED is enabled on ports that are configured to both receive and transmit LLDP packets and have
the LLDP-MED capabilities TLV enabled.
LLDP-MED configuration
FastIron Ethernet Switch Administration Guide 187
53-1003075-02