Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 109)

Error
code Message Explanation and action
8 File type check failed. You accidentally attempted to copy the incorrect image code into the
system. For example, you might have tried to copy a Chassis image into
a Compact device.
Retry the transfer using the correct image.
16 TFTP remote - general
error. The TFTP configuration has an error. The specific error message
describes the error.
Correct the error, then retry the transfer.
17 TFTP remote - no such
file.
18 TFTP remote - access
violation.
19 TFTP remote - disk full.
20 TFTP remote - illegal
operation.
21 TFTP remote - unknown
transfer ID.
22 TFTP remote - file
already exists.
23 TFTP remote - no such
user.
This section describes the error messages associated with the TFTP transfer of PoE firmware file to a
Brocade device.
Message Explanation and action
Firmware TFTP timeout. TFTP failed because of a time out.
Check IP connectivity and make sure the TFTP server is running.
Firmware is not valid for this
platform. Each PoE firmware file delivered by Brocade is meant to be used on the specific
platform only. If the file is used on a platform for which it is not meant, then this error
message will display.
Download the correct file, then retry the transfer.
Firmware is not valid for the
IEEE 802.3at (PoE-Plus)
controller type. Each PoE firmware file delivered by Brocade is meant to be used on the specific
platform only. If the file is used on a platform for which it is not meant, then this error
message will display.
Download the correct file, then retry the transfer.
Firmware is not valid for the
IEEE 802.3af PoE controller
type.
Operations, Administration, and Maintenance
FastIron Ethernet Switch Administration Guide 109
53-1003075-02