Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 238)

Relay Agent Information option: Disabled
Egress queues:
Queue counters Queued packets Dropped Packets
0 0 0
1 0 0
2 1 0
3 0 0
4 0 0
5 0 0
6 0 0
7 215703 0
Syntax: show interface [ ethernet port]
Specify the port variable in the format stack-unit/slotnum/portnum.
Egress queue statistics TABLE 34
Parameter Description
Queue counters The QoS traffic class.
Queued packets The number of packets queued on the port for the given traffic class.
Dropped packets The number of packets for the given traffic class that were dropped because of congestion.
Viewing egress queue counters on ICX 7750 devices
Viewing egress queue counters on ICX 7750 devices.
For a port, the show interface command displays the number of packets that were queued for each
QoS priority (traffic class) and dropped because of congestion. The egress queue counters are
displayed at the end of the show interface command output as shown in the following example.
NOTE
This command output displays the total of unicast and multicast counters for any particular QOS
priority.
Brocade# show interface ethernet 1/1/1
10GigabitEthernet 1/1/1 is down, line protocol is down
Port down for 16 hours 16 minutes 48 seconds
Hardware is 10GigabitEthernet , address is 748e.f8f9.6280 (bia 748e.f8f9.6280)
Interface type is 40Gig Fiber
Configured speed 40Gbit, actual unknown, configured duplex fdx, actual unknown
Configured mdi mode AUTO, actual unknown
Member of L2 VLAN ID 1, port is untagged, port state is BLOCKING
BPDU guard is Disabled, ROOT protect is Disabled, Designated protect is Disabled
Link Error Dampening is Disabled
STP configured to ON, priority is level0, mac-learning is enabled
Flow Control is enabled
Mirror disabled, Monitor disabled
Mac-notification is disabled
Not member of any active trunks
Not member of any configured trunks
No port name
IPG MII 96 bits-time, IPG GMII 96 bits-time
MTU 1500 bytes
300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 multicasts, 0 unicasts
0 input errors, 0 CRC, 0 frame, 0 ignored
0 runts, 0 giants
0 packets output, 0 bytes, 0 underruns
Transmitted 0 broadcasts, 0 multicasts, 0 unicasts
Viewing egress queue counters on ICX 7750 devices
238 FastIron Ethernet Switch Administration Guide
53-1003075-02