Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 108)

Displaying the amount of time remaining beforea scheduled reload
To display how much time is remaining before a scheduled system reload, enter the following
command from any level of the CLI.
device#show reload
Canceling a scheduled reload
To cancel a scheduled system reload using the CLI, enter the following command at the global
CONFIG level of the CLI.
device#reload cancel
Diagnostic error codes and remedies for TFTP transfers
This section describes the error messages associated with TFTP transfer of configuration files,
software images or flash images to or from a Brocade device.
Error
code Message Explanation and action
1 Flash read preparation
failed. A flash error occurred during the download.
Retry the download. If it fails again, contact customer support.
2 Flash read failed.
3 Flash write preparation
failed.
4 Flash write failed.
5 TFTP session timeout. TFTP failed because of a time out.
Check IP connectivity and make sure the TFTP server is running.
6 TFTP out of buffer space. The file is larger than the amount of room on the device or TFTP server.
If you are copying an image file to flash, first copy the other image to
your TFTP server, then delete it from flash. (Use the erase flash ... CLI
command at the Privileged EXEC level to erase the image in the flash.)
If you are copying a configuration file to flash, edit the file to remove
unnecessary information, then try again.
7 TFTP busy, only one
TFTP session can be
active. Another TFTP transfer is active on another CLI session or network
management system.
Wait, then retry the transfer.
Displaying the amount of time remaining beforea scheduled reload
108 FastIron Ethernet Switch Administration Guide
53-1003075-02