Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 359)

The src-tcp / udp-port is the source TCP or UDP port, if applicable, of the
denied packets.
The portnum indicates the port number on which the packet was denied.
The mac-addr indicates the source MAC address of the denied packets.
The dst-ip-addr indicates the destination IP address of the denied packets.
The dst-tcp / udp-port indicates the destination TCP or UDP port number, if
applicable, of the denied packets.
Message
Level Warning
Message MAC filter group denied packets on port portnum,
src macaddr mac-addr , num packets
Explanation Indicates that a MAC address filtergroup configured on a port has denied
packets.
The portnum is the port on which the packets were denied.
The mac-addr is the source MAC address of the denied packets.
The num indicates how many packets matching the values above were
dropped during the five-minute interval represented by the log entry.
Message Level Warning
Message multicast no software resource: resource-name ,
rate-limited number
Explanation IGMP or MLD snooping has run out of software resources. This message
is rate-limited to appear a maximum of once every 10 minutes. The rate-
limited number shows the number of non-printed warnings.
Message Level Warning
Message No global IP! cannot send IGMP msg.
Explanation The device is configured for ip multicast active but there is no configured
IP address and the device cannot send out IGMP queries.
Message Level Warning
Message No of prefixes received from BGP peer ip-addr
exceeds warning limit num
Explanation The Layer 3 switch has received more than the allowed percentage of
prefixes from the neighbor.
The ip-addr is the IP address of the neighbor.
Syslog messages
FastIron Ethernet Switch Administration Guide 359
53-1003075-02