beautypg.com

Specifying an ipv6 host as an snmp trap receiver, Snmp v3 over ipv6, Restricting snmp access to an ipv6 node – Brocade FastIron Ethernet Switch Administration Guide User Manual

Page 148: Viewing ipv6 snmp server addresses

background image

Specifying an IPv6 host as an SNMP trap receiver

You can specify an IPv6 host as a trap receiver to ensure that all SNMP traps sent by the device will
go to the same SNMP trap receiver or set of receivers, typically one or more host devices on the
network. To do so, enter a command such as the following.

device(config)#snmp-server host ipv6 2001:DB8:89::13

Syntax: snmp-serverhost ipv6 ipv6-address

The ipv6-address must be in hexadecimal format using 16-bit values between colons as documented
in RFC 2373.

SNMP v3 over IPv6

Some FastIron devices support IPv6 for SNMP version 3.

Restricting SNMP Access to an IPv6 Node

You can restrict SNMP access so that the Brocade device can only be accessed by the IPv6 host
address that you specify. To do so, enter a command such as the following .

device(config)#snmp-client ipv6 2001:DB8:89::23

Syntax: snmp-clientipv6 ipv6-address

The ipv6-address must be in hexadecimal format using 16-bit values between colons as documented
in RFC 2373.

Specifying an IPv6 host as an SNMP trap receiver

You can specify an IPv6 host as a trap receiver to ensure that all SNMP traps sent by the Brocade
device will go to the same SNMP trap receiver or set of receivers, typically one or more host devices
on the network. To do so, enter the snmp-server host ipv6 command .

device(config)#snmp-server host ipv6 2001:DB8:89::13

Syntax: snmp-serverhost ipv6 ipv6-address

The ipv6-address must be in hexadecimal format using 16-bit values between colons as documented
in RFC 2373.

Viewing IPv6 SNMP server addresses

Many of the existing show commands display IPv6 addresses for IPv6 SNMP servers. The following
example shows output for the show snmp server command.

device#show snmp server

Contact:

Location:

Community(ro): .....

Traps

Warm/Cold start: Enable

Link up: Enable

Link down: Enable

Authentication: Enable

Locked address violation: Enable

Specifying an IPv6 host as an SNMP trap receiver

148

FastIron Ethernet Switch Administration Guide

53-1003075-02