EVS XT3 Version 11.00 Configuration Manual - Manual (Page 9)

• The Remote Control panel now includes:
◦
a technical setup menu that gives access to the most commonly used technical
settings.
◦ an operational setup menu that only provides operational settings.
The following table gives an overview on the features available in each user interface:
EVS Server Configuration
Setup Window Configuration Window
Technical
Settings
Operational
Settings
Server-Based
Application Yes Yes
(tabs 1-6)
Yes
(tab 7)
web-based
interface Yes
(except some Tools
commands)
Yes
(tabs 1-6)
Yes
(tab 7)
Remote Panel No Yes
(Technical Setup
F0)
Yes
(Setup Menu
SHIFT+D)
1.2. Introduction to the Manual
Merging of Former Manuals
The XT3 server Configuration manual is the successor of the former Software Technical
Reference manual and Multicam Configuration manual.
Both manuals have been merged into a single manual due to the in-depth reorganization of
the software modules that allow configuring the EVS video servers. The Configuration
manual is server-related.
Note
This version of the XT3 Configuration manual has been completed compared to
the version issued with the Multicam 11.00 release.
Documented User Interfaces
The Server Configuration manual deals with all user interfaces used to configure
Multicam: server-based application, web-based interface, and LSM Remote Panel.
• On the one hand, the information on navigability and editing commands, specific to the
user interface, is described in clearly separated sections.
• On the other hand, the reference information on and the description of configuration
parameters are described in common sections valid for all user interfaces. A clear
overview shows whether and where the parameters are available in each user
interface.
XT3 Server - Version 11.00 - Configuration Manual
1. Introduction 3