EVS XT3 Version 11.00 Configuration Manual - Manual (Page 218)

# of
Remotes
1 2 3 4
Hypermotion
Mode Hyperm.
Only Hyperm.
+ LSM Hyperm.
Only Hyperm.
+ LSM Hyperm.
Only Hyperm.
+ LSM Hyperm.
Only Hyperm.
+ LSM
1 OUT NA R1: PGM1
+hyperm.
R1: PGM1
R2:
hyperm.
NA NA NA NA NA
2 OUT NA R1:
PGM1
+PGM2
+hyperm. R1: PGM1
+PGM2
R2:
hyperm.
R1: PGM1
R2: PGM2
+hyperm.
R1: PGM1
R2: PGM2
R3:
hyperm.
NA NA NA
3 OUT NA R1: PGM1
+PGM2
+PGM3
+hyperm.
R1: PGM1
+PGM2
+PGM3
R2:
hyperm.
R1: PGM1
+PGM2
R2: PGM3
+hyperm.
R1: PGM1
+PGM2
R2: PGM3
R3:
hyperm.
R1: PGM1
R2: PGM2
R3: PGM3
+hyperm.
R1: PGM1
R2: PGM2
R3: PGM3
R4:
hyperm.
NA
4 OUT NA R1: PGM1
+PGM2
+PGM3
+hyperm.
R1: PGM1
+PGM2
+PGM3
R2:
hyperm.
R1: PGM1
+PGM2
+PGM3
R2: PGM4
+hyperm.
OR
R1: PGM1
+PGM2
R2: PGM3
+PGM4
+hyperm.
R1: PGM1
+PGM2
R2: PGM3
+PGM4
R3:
hyperm.
R1: PGM1
+PGM2
R2: PGM3
R3: PGM4
+hyperm.
R1: PGM1
+PGM2
R2: PGM3
R3: PGM4
R4:
hyperm.
R1: PGM1
R2: PGM2
R3: PGM3
R4: PGM4
+hyperm.
‘PGM1+PGM2’ can represent the 2PGMs mode as well as the PGM/PRV mode.
Warning
The cells with ‘NA’ correspond to impossible configurations taking into account
the existing constraints. In this case, the Hypermotion option is not available in
the operational menu even if the Hypermotion setting is set to ‘Yes’.
3.8.14. Hypermotion Controller Settings
Introduction
The Hypermotion controller settings allow specifying the settings related to the control of
a hypermotion camera from an LSM Remote Panel.
These fields are available in the following interfaces:
• in the Multicam Configuration window, Operation tab, in the basic display mode:
◦
on page 5 on the server-based application.
◦ on page 1 on the web-based interface.
• in the Operational setup menu of the Remote Control Panel (pages 11.1 and 11.2).
XT3 Server - Version 11.00 - Configuration Manual
3. Multicam Configuration 212