EVS XT3 Version 11.00 Configuration Manual - Manual (Page 193)

Default copy/move
Description Specifies whether the copy operations should be executed
preferably using the SDTI or the Gigabit network.
Values Two values are possible for this parameter:
• SDTI:
The copy operations are first executed through the SDTI
network. If the SDTI network is temporarily unavailable,
the transfer is then tried through the Gigabit interface.
Transfers to GigE targets will always be performed via the
GigE interface.
• Gigabit:
The copy operations are first executed via the GigE
interface. If the transfer is not possible (ports not
connected, IP address unknown, no more connection
ports are available), the transfer is then tried through SDTI.
The value is forced to Gigabit if the code 117 (SDTI) is not
valid on the EVS server, or if the SDTI network is not active.
Default value SDTI
Freeze on cue points
Description Specifies whether Multicam will freeze or not when it reaches
a cue point marked on the record train that is being played
back.
The Post-Roll parameter is not taken into account for this
functionality.
Values Yes / No
When playing record trains where cue points have been
marked, the playout freezes on the cue point if the parameter
is set to “Yes”. It plays through if the parameter is set to “No”.
Default value No
Protocol Receive page
Description Specifies on which page the clips created by protocols are
stored. When a page is full, clips are stored on the next page.
Only clips created on this page (and the other protocol pages if
the first page is full) are visible for protocols.
Values 1 to 10 (=0)
Default value 6
187 3. Multicam Configuration
EVS Broadcast Equipment S.A. - April 2012 Issue 11.00.C