EVS XT3 Version 11.00 Configuration Manual - Manual (Page 40)

2.5. Server Maintenance
2.5.1. Chapter Contents
The table below presents the topics of this section and shows whether the described
features available from the web-based interface and/or from the server-based interface.
Commands Server-Based
Web-
Based
"Rebooting the EVS Server" on page 34 Yes No
"Hardware Check" on page 34 Yes No
"Clearing Video Disks" on page 38 Yes No
"Calibrating a Touch Screen" on page 38 Yes No
"Importing and Exporting Keyword Files" on page 38 Yes No
"Exporting Log Files" on page 39 Yes No
2.5.2. Rebooting the EVS Server
To reboot the EVS server, press B from the Multicam Setup window, then RIGHT
ARROW and ENTER to validate the action.
2.5.3. Hardware Check
Overview on the Hardware Check
Purpose
During the hardware check, the following actions are performed:
• Retrieving and checking relevant information related to the various boards installed on
the EVS server
• Verifying the validity of the data recorded on the video disk array
The hardware check is only available in the server-based application.
Tip
Hardware check is also used to rebuild the video and audio information after
replacing a faulty disk.
XT3 Server - Version 11.00 - Configuration Manual
2. Multicam Setup 34