EVS XT3 Version 11.00 Configuration Manual - Manual (Page 31)

How to Set the LAN PC
To set up the LAN PC on the EVS server, proceed as follows:
1. In the Multicam Setup window, press L to call the Set LAN PC address command.
The following window opens:
2. In this window, type the IP address, subnet mask, and default gateway. Use the TAB
key to move from one field to the other.
3. Press ENTER to validate the definition of the LAN PC settings.
The LAN PC settings will automatically be taken into account when you launch a
configuration line.
2.3.5. Setting the Server Date and Time
Introduction
The Set Date and Time command allows you to adjust the system time & date from the
Multicam Setup window in the server-based application. This is not available in the web-
based interface.
Note
When you have just launched a configuration, a window displaying the system
date and time gives you another opportunity to modify these parameters.
Supported Formats
The supported date format is DD-MM-YYYY, as shown in the example below:
• 15-03-2011 for March 15, 2011
The supported time format is hh:mm:ss, as shown in the example below
• 22:58:00 for 22 h 58 min 00 sec (24-hour display)
A warning message will inform you if the format you try to use is not valid.
25 2. Multicam Setup
EVS Broadcast Equipment S.A. - April 2012 Issue 11.00.C