EVS XT3 Version 11.00 Configuration Manual - Manual (Page 52)

Command description Command key
Resetting all values of all settings in all tabs for the
selected configuration SHIFT+F5
Applying changes ALT+A
Leaving without applying changes ESC, ENTER
Enabling Values in a List
Some settings allow you to enable values in a list of displayed values. This is, for
example, the case with the selection of pages (receive pages, protect pages) in the
Operation tab.
The enabled pages are highlighted in blue, and the disabled pages are not highlighted.
To enable a list of values for a given setting, proceed as follows:
1. Select the list of values with the TAB key.
Once the list of values is selected, the enabled values stay highlighted in blue, and the
disabled values are highlighted in pink.
2. On the keyboard, type the page numbers you want to enable. They become
highlighted in blue.
3. Apply the changes with ALT+A, and confirm the action.
In the Web-Based Interface
Navigation and Editing Commands
The navigation and editing commands in the web-based interface are the commonly used
commands in a web-based interface. The command buttons available are the following
ones:
Command description Command key
Activating the Advanced display mode
Coming back to the Basic display mode
Applying changes
Canceling changes
XT3 Server - Version 11.00 - Configuration Manual
3. Multicam Configuration 46