beautypg.com

Exit, Restarting – EVS XT3 Version 11.00 Configuration Manual User Manual

Page 42

background image

Exit

When exiting the Multicam application, a warning will appear to remind the operator that
one disk was disconnected, and invite him to perform a hardware check to repair the video
raid. This is displayed even if a spare disk is available:

if the faulty disk is a spare disk:

"Warning: a spare disk has been disconnected. At the next

opportunity please consider replacing the faulty disk. It can

be identified in the Shift-F5 screen or in the EVS - RAID

configuration menu. [Enter]=Continue"

if the faulty disk is contained in a RAID:

"Warning: a disk has been disconnected. At the next opportunity

please consider replacing the faulty disk. It can be identified

in the Shift-F5 screen or in the EVS - RAID configuration menu.

[Enter]=Continue"

Restarting

If the Multicam is restarted without the RAID being rebuilt, the following message is
displayed during the bootwins:

if a spare disk is OK:
[ Bad ] SEAGATE ST9300603SS   3SE10H1J   0006  279GB 02 07

if no spare disk is OK and the RAID is no more complete:
[ Bad ] SEAGATE ST9300603SS   3SE10H1J   0006  279GB 02 07
WARNING !!! Tray XX is missing 1 disk(s) to be complete

Then when entering the Multicam, another message appears, even if a spare disk is
available:

if the faulty disk is a spare disk:

"Warning: a spare disk has been disconnected. The system will

operate normally on the remaining disks. At the next

opportunity please consider replacing the faulty disk. It can

be identified in the Shift-F5 screen or in the EVS - RAID

configuration menu. [Enter]=Continue"

if the faulty disk is contained in a RAID:

"Warning: a disk has been disconnected. The system will operate

normally on the remaining disks. At the next opportunity please

consider replacing the faulty disk. It can be identified in the

Shift-F5 screen or in the EVS - RAID configuration menu.

[Enter]=Continue"

The operator can press ENTER and operate normally on 4 disks (configuration “4+1”) or
on 5 disks (configuration “5+1”) or exit the software and return to Multicam Setup window
to run a hardware check.

XT3 Server - Version 11.00 - Configuration Manual

2. Multicam Setup

36