EVS XT3 Version 11.00 Configuration Manual - Manual (Page 134)

3.3.5. Timecode and Data Insertion
Timecode Settings
Introduction
The Timecode settings allow specifying which type of timecode the users want to use as
the reference to work on a given recorder of an EVS server.
The selection of a timecode type, using the timecode settings, rely on the management of
two timecode jump tables.
These fields are available in the following interfaces:
• in the Multicam Configuration window, Channels tab, in the advanced display mode:
◦
on page 6, 7 or 8 on the server-based application.
◦ on page 1 on the web-based interface.
• partly in the Technical menu of the Remote Control Panel (T2.12).
The following screenshot presents page 8 of the Channels tab in the server-based
application, where the Timecode settings are available, and highlights the Timecode
settings area:
LTC
Description Longitudinal timecode (timecode defined on or plugged into the
EVS server) automatically stored in the first timecode jump
table (LTC table).
This is not possible to modify the timecode type stored in the
first timecode jump table.
Values LTC (non-editable)
XT3 Server - Version 11.00 - Configuration Manual
3. Multicam Configuration 128