EVS XT3 Version 11.00 Configuration Manual - Manual (Page 54)

Tab Name Setting Name
Network tab All SDTI settings:
• Speed
• Net name
• Net number
• Type
Network tab All Gigabit Ethernet settings:
• IP address
• Subnet mask
• Default gateway
Monitoring tab One setting in the Downconverted Outputs area:
• Aspect ratio
3.1.4. Overview on the Setup Menus in the Remote
Panel
Introduction
When you work in LSM mode, the Technical and Operational Setup menus available on
the Remote Panel allow you to define:
• the commonly used technical settings in the Technical Setup menu
• all operational settings in the Operational Setup menu.
The values assigned to the settings are saved as soon as they are modified.
Accessing the Technical Setup Menu
To access the Technical Setup menu, press F0 from the Main Setup page.
The Technical Setup menu opens on the 1st page.
The Technical Setup menu is divided in sections and subsections, named by Tx.y where
x is the section number, and y the subsection number.
In all sections dedicated to a tab of the Multicam Configuration window in this manual, you
will find an overview table that lists the settings available in the Technical Setup menu, as
well as the sections where you will find them.
XT3 Server - Version 11.00 - Configuration Manual
3. Multicam Configuration 48