EVS XT3 Version 11.00 Configuration Manual - Manual (Page 191)

Autoname clips
Description If this function is enabled, the value of the selected field will
automatically be used to name the clip upon creation.
Values The values from the following fields can be used to
automatically name clips:
• Disabled:
No name is assigned to a clip when it is created.
• TC IN:
The timecode of the IN point of the clip is automatically
assigned to a clip when it is created.
• CAM Name:
The name of the record channel is automatically assigned
to a clip when it is created.
• ID Louth:
The ID Louth of the clip, i.e. the unique identifier for the clip
on the XNet network, is assigned to a clip when it is
created.
• Var ID 32:
The VarID of the clip is assigned to a clip when it is
created.
When this option is selected, the VarID used to assign a
name to the clip will be limited to the first 8 characters of
this field.
Default value Disabled
Clip post-roll
Description When the Post-Roll function is enabled from the secondary
clip menu, the clip will play through its OUT point for the
duration defined by the Clip post-roll parameter.
This is also valid inside record trains if the Record Train OUTs
parameter is set to 'Freeze'.
Values From 00s00fr to 30s00fr
Default value 02s00fr
185 3. Multicam Configuration
EVS Broadcast Equipment S.A. - April 2012 Issue 11.00.C