EVS XT3 Version 11.00 Configuration Manual - Manual (Page 55)

Accessing the Operational Setup Menu
To access the Operational Setup menu, proceed as follows:
1. If you are in Playlist mode, press RECORD first to exit this mode.
2. Press SHIFT + MENU to go to the Main menu:
3. Select Setup by pressing SHIFT + D to enter the Operational Setup menu.
The Operational Setup menu is divided in sections and subsections, named by x.y where
x is the section number, and y the subsection number.
3.1.5. Navigating and Editing in the Setup Menus of
the Remote Panel
Introduction
The way you navigate and edit settings is identical in the Technical Setup menu and
Operational Setup menu. The navigation and editing commands are explained below.
Navigation Commands
The following table presents the commands to navigate in the Setup menus of the Remote
Panel:
Command description Command key
Moving to another section when you are inside a section SHIFT+F_ key
corresponding to the
section
Moving to the next page inside a section
When you are on the last page of a section, you will go to the
1st page of the next section. F10
Moving to the previous page inside a section
When you are on the first page of a section, you will go to the
last page of the previous section. F9
Exiting the Setup menu Menu
Scrolling through section pages with the jog wheel ENTER (when no
setting is selected) + jog
49 3. Multicam Configuration
EVS Broadcast Equipment S.A. - April 2012 Issue 11.00.C