EVS XT3 Version 11.00 Configuration Manual - Manual (Page 68)

3.2.3. Phase Definition Settings
Introduction
The Phase Definition settings are available on the Server tab in the server-based
application (1st page) and web-based interface in the advanced mode.
The Phase Definition settings are highlighted in the screenshot of the server-based
application shown below:
SD (Standard Definition)
Description Allows adjusting the digital main phase of the mainframe for
the standard definition. The value is adjusted by steps of half
pixels.
The values depends on the genlock type (See "Video and
Reference Settings" on page 52).
Values • If the Genlock type is set to ‘Blackburst’, the main phase
for SD can be adjusted by steps of half pixels (37 ns)
between
- 12000 ns and +15000 ns.
• If the Genlock type is set to ‘Tri-Sync’ (only possible in HD
resolutions), the main phase for SD can be adjusted by
steps of half pixels (37 ns) between - 30000 ns and +32000
ns.
XT3 Server - Version 11.00 - Configuration Manual
3. Multicam Configuration 62