EVS XT3 Version 11.00 Configuration Manual - Manual (Page 144)

Speed
Description Enables the selection of the SDTI option and the bandwidth for
the network.
On theXT3 server, there is one pair of SDTI connectors:
XNet2 Non-Relay connectors are used at 1485 Mbps.
The SDTI circuit is closed only when the Multicam software is
started.
Values No Relay 1485 (Mbps) / Off
Net Name
Description Machine name on the SDTI network.
It is not mandatory because a network number is assigned to
the EVS server. It is however recommended to easily identify
all servers connected to the XNet network.
The Net Name will be displayed even if the SDTI code is not
valid.
Values The Net Name is user-defined and cannot exceed 8
characters.
Default Values By default, no Net Name is assigned.
Net Number
Description The Net Number parameter defines the machine number on
the network. This number is user-defined and must be unique
for each system on the network. When entering a new number
if this number is already assigned to another machine, an error
message will warn the user.
Values Range between 1 and 29
Default 1
XT3 Server - Version 11.00 - Configuration Manual
3. Multicam Configuration 138