EVS XT3 Version 11.00 Configuration Manual - Manual (Page 205)

3.8.9. Push Settings
Introduction
The Push settings relate to the management of the Push function on the EVS server. The
Push function allows users to easily send a copy of a clip to another machine on the
network, either via the GigE network or the SDTI network.
These fields are available in the following interfaces:
• in the Multicam Configuration window, Operation tab, in the basic display mode:
◦
on page 3 on the server-based application.
◦ on page 1 on the web-based interface.
• in the Operational setup menu of the Remote Control Panel (7.1).
Warning
The values available in the Push settings depend on the presence of the SDTI
hardware or GigE hardware, and on the value of the Speed setting in the
Network tab.
The following screenshot presents page 3 of the Operation tab in the server-based
application, where the Push settings are available, and highlights the Push settings area:
199 3. Multicam Configuration
EVS Broadcast Equipment S.A. - April 2012 Issue 11.00.C