EVS XT3 Version 11.00 Configuration Manual - Manual (Page 163)

Time Code Settings for Edit Rec
Introduction
The Time Code settings allow specifying the timecode (TC) types used in various
communication protocols.
These fields are available in the following interfaces:
• in the Multicam Configuration window, Protocol tab, on page 2 for Edit Rec 1 and on
page 3 for Edit Rec 2, in the basic and advanced display mode in the server- and web-
based interfaces (some parameters are only available in the advanced mode).
• in the Technical menu of the Remote Control Panel, pages T5.3-4 for Edit Rec 1 and
on page T5.6-7 for Edit Rec 2.
The following screenshot presents page 2 in advanced mode of the Protocol tab in the
server-based application and highlights the Time Code settings area.
Serial Sony LTC
Description Specifies the type of timecode used in communications
between the Sony controller and the Edit Rec engine when the
controller works with the LTC.
Values This field is not editable.
The value is always Edit TC, meaning the timecode of the
playlist based on the Start TC.
157 3. Multicam Configuration
EVS Broadcast Equipment S.A. - April 2012 Issue 11.00.C