EVS XT3 Version 11.00 Configuration Manual - Manual (Page 71)

Four Lines
Description Enables or disables the four-line interpolation process.
Values • No (default)
• Yes
3.2.5. PC LAN Settings
Introduction
The PC LAN settings are available on the Server tab in the server-based application
(1st page) and web-based interface in the advanced mode.
The PC LAN settings are highlighted in the screenshot of the server-based application
shown below:
Note
The PC LAN settings are read-only in the Multicam Configuration window. You
can modify them in the Multicam Setup window, using the Set LAN PC
address command. For more information, see section "Setting the Server LAN
PC Address" on page 24.
General Description
The PC LAN settings allow the MTPC board of an EVS server to communicate and
exchange information with other EVS hardware on a setup.
IP Address
Description IP address to connect to the port #1 of the MTPC board on the
server.
Values The IP addresses 0.0.0.0 and 255.255.255.255 are not
allowed.
65 3. Multicam Configuration
EVS Broadcast Equipment S.A. - April 2012 Issue 11.00.C