Server parameters, Chapter contents, Assigning a server facility name – EVS XT3 Version 11.00 Configuration Manual User Manual
Page 27: Assign server facility name, Introduction

2.3.
Server Parameters
2.3.1.
Chapter Contents
The table below presents the topics of this section and shows whether the described
features are available from the web-based interface and/or from the server-based
interface.
Commands
Server-Based
Web-
Based
"Assigning a Server Facility Name" on page 21
Yes
Yes
"Activating and Deactivating the Password Protection"
on page 22
Yes
No
"Setting the Server LAN PC Address" on page 24
Yes
No
"Setting the Server Date and Time" on page 25
Yes
No
"Setting the Default Output To VGA/Video" on page 26
Yes
No
"Configuring Server Raids" on page 27
Yes
No
2.3.2.
Assigning a Server Facility Name
Introduction
You can assign a facility name to the EVS server. It allows the identification of the EVS
server with a dedicated name, besides the server's serial number. This name is
independent from any configuration.
The server facility name differs from the server net name, which can vary from a
configuration to the other as it is defined in the configuration parameters.
The server facility name is displayed in the title bar of the Multicam setup and
configuration windows, as well as on the OSD (on-screen display).
21
2. Multicam Setup
EVS Broadcast Equipment S.A. - April 2012
Issue 11.00.C