Overview on configuration parameters – EVS XT3 Version 11.00 Configuration Manual User Manual
Page 47
Overview on Configuration Parameters
The first topic of each section in the Multicam Configuration chapter gives you an
overview on the parameters available in this section, and specifies whether you will find
the parameter:
•
in the basic or advanced view in the server-based application and the web-based
interface
•
in the Technical Setup, Operational Setup, or not at all on the Remote Control panel
The following list provides a hyperlink to all overview topics in the various sections:
•
•
•
•
•
•
•
Concurrent Modifications in the Remote Panel and the
Server-Based Application
When a parameter is modified with the Remote Panel, and that parameter is not in conflict
with the parameter modified in the Configuration page of the server-based application, the
following message will be displayed on the VGA.
'The configuration has been modified by another user without
any conflict. Your copy has been updated with these
modifications.'
When a parameter is modified with the Remote Panel, and the parameter is in conflict with
the parameter modified in the Configuration page of the server-based application, the
following message shall be displayed on the VGA or on the LCD display of the Remote
Panel. The configuration shall be updated if the user agrees.
'The configuration has been modified by another user.
Do you want to load it and lose your modification?'
Warning
When this message is displayed on the Remote Panel and the user answers
'No' to the message (Clear button), the modifications performed on the Remote
Panel will be preserved. The changes applied on the VGA will however be
loaded after the user leaves the operational setup menu, except if the specific
fields modified on the VGA have been modified and validated on the Remote
Panel after the message display.
41
3. Multicam Configuration
EVS Broadcast Equipment S.A. - April 2012
Issue 11.00.C