EVS XT3 Version 11.00 Configuration Manual - Manual (Page 113)

3D/1080p SLSM Configurations
Assignment Principles
The combination of 3D or 1080p standards and SLSM configurations associates the
individual rules for connector assignments on the rear panel:
• For 3D or 1080p in Dual link, the primary link of a codec module is used for the first
connector, and the secondary link for the same codec module is used for the second
connector.
• For 3D or 1080p in 3G (single link), the primary link of the codec module is used for the
single connector. However, both primary and secondary links of a codec module of
the V3X board are used.
• For the SLSM 2 Phase configurations, one SLSM recorder accounts for one logical
channel, but corresponds to two physical channels. This means that the primary
connectors of two codec modules will be used for one SLSM 2 Phase recorder.
• For the SLSM 3 Phase configurations, one SLSM recorder accounts for one logical
channel, but corresponds to three physical channels. This means that the primary
connectors of three codec modules will be used for one SLSM 3 Phase recorder.
XT3 4U Servers
Available SLSM 2x Configurations
The table below shows the available 3D and 1080p configurations with SLSM 2 Phase
cameras on a XT3 4U server. The table shows the link assignment at the level of the
codec module of a V3X board.
IN4/OUT1 IN3/OUT2 IN2/OUT3 IN1/OUT4
#REC
SLSM
2x
#REC #PLAY
Prim.
Link Sec.
Link Prim.
Link Sec.
Link Prim.
Link Sec.
Link Prim.
Link Sec.
Link
1 0 0 REC
1,2A
REC
1,2B
REC
1,1A
REC
1,1B
1 1 0 REC
2A
REC
2B
REC
1,2A
REC
1,2B
REC
1,1A
REC
1,1B
1 2 0 REC
3A
REC
3B
REC
2A
REC
2B
REC
1,2A
REC
1,2B
REC
1,1A
REC
1,1B
2 0 0 REC
2,2A
REC
2,2B
REC
2,1A
REC
2,1B
REC
1,2A
REC
1,2B
REC
1,1A
REC
1,1B
1 0 1 PLAY
1A
PLAY
1B
REC
1,2A
REC
1,2B
REC
1,1A
REC
1,1B
1 1 1 PLAY
1A
PLAY
1B
REC
2A
REC
2B
REC
1,2A
REC
1,2B
REC
1,1A
REC
1,1B
1 0 2 PLAY
1A
PLAY
1B
PLAY
2A
PLAY
2B
REC
1,2A
REC
1,2B
REC
1,1A
REC
1,1B
107 3. Multicam Configuration
EVS Broadcast Equipment S.A. - April 2012 Issue 11.00.C