SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 74)

C
ONFIGURING THE
S
WITCH
3-24
To delete a file, select System, File, Delete. Select the file name from the
given list by checking the tick box and then click Apply. Note that the file
currently designated as the startup code cannot be deleted.
Figure 3-10 Deleting Files
CLI – To download new firmware from a TFTP server, enter the IP
address of the TFTP server, select “opcode” as the file type, then enter the
source and destination file names. When the file has completed the
download, set the new file to start up the system and then restart the
switch.
To start the new firmware, enter the “reload” command or reboot the
system.
Saving or Restoring Configuration Settings
You can upload/download configuration setting files to/from a TFTP
server or copy files to and from switch units in a stack. The configuration
files can be later downloaded to restore the switch’s settings.
Console#copy tftp file 4-84
TFTP server ip address: 192.168.1.200
Choose file type:
1. config: 2. opcode 3. PD_Controller: <1-3>: 2
Source file name: SMC6824MPE_Opcode_V2.3.3.5.bix
Destination file name: smcv2.3.3.5
/
Console#config
Console(config)#boot system opcode: V1003.bix
4-91
Console(config)#exit
Console#reload
4-31