SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 272)

C
OMMAND
L
INE
I
NTERFACE
4-10
• Line Configuration - These commands modify the console port and
Telnet configuration, and include commands such as parity and
databits.
• VLAN Configuration - Includes the command to create VLAN groups.
To enter the Global Configuration mode, enter the command configure in
Privileged Exec mode. The system prompt will change to
“Console(config)#” which gives you access privilege to all Global
Configuration commands.
To enter the other modes, at the configuration prompt type one of the
following commands. Use the exit or end command to return to the
Privileged Exec mode.
For example, you can use the following commands to enter interface
configuration mode, and then return to Privileged Exec mode.
Console#configure
Console(config)#
Table 4-2 Configuration Commands
Mode Command Prompt Page
Line line {console | vty} Console(config-line)# 4-14
Access
Control
List access-list ip standard
access-list ip extended
access-list ip mask-precedence
access-list mac
access-list mac
mask-precedence Console(config-std-acl)
Console(config-ext-acl)
Console(config-ip-mask-acl)
Console(config-mac-acl)
Console(config-mac-mask-acl) 4-122
Interface interface {ethernet port |
port-channel id| vlan id}
Console(config-if)# 4-173
VLAN vlan database Console(config-vlan) 4-227
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#