SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 425)

SNMP C
OMMANDS
4-163
• The snmp-server enable traps command is used in conjunction with
the snmp-server host command. Use the snmp-server host command
to specify which host or hosts receive SNMP notifications. In order to
send notifications, you must configure at least one snmp-server host
command.
Example
Related Commands
snmp-server host (4-160)
show snmp
Use this command to check the status of SNMP communications.
Default Setting
None
Command Mode
Normal Exec, Privileged Exec
Command Usage
This command provides information on the community access strings,
counter information for SNMP input and output protocol data units, and
whether or not SNMP logging has been enabled with the snmp-server
enable traps command.
Console(config)#snmp-server enable traps link-up-down
Console(config)#