SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 532)

C
OMMAND
L
INE
I
NTERFACE
4-270
Static Multicast Routing Commands
ip igmp snooping vlan mrouter
Use this command to statically configure a multicast router port. Use the no
form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4094)
• interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
Depending on your network connections, IGMP snooping may not
always be able to locate the IGMP querier. Therefore, if the IGMP
querier is a known multicast router/switch connected over the network to
an interface (port or trunk) on your switch, you can manually configure
that interface to join all the current multicast groups.
Table 4-68 Static Multicast Routing Commands
Command Function Mode Page
ip igmp snooping vlan
mrouter Adds a multicast router port GC 4-270
show ip igmp snooping
mrouter Shows multicast router ports PE 4-271