SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 115)

U
SER
A
UTHENTICATION
3-65
CLI – Specify all the required parameters to enable logon authentication.
Configuring HTTPS
You can configure the switch to enable the Secure Hypertext Transfer
Protocol (HTTPS) over the Secure Socket Layer (SSL), providing secure
access (i.e., an encrypted connection) to the switch’s web interface.
Command Usage
• Both the HTTP and HTTPS service can be enabled independently on
the switch. However, you cannot configure both services to use the
same UDP port.
Console(config)#authentication login radius 4-100
Console(config)#radius-server port 181 4-104
Console(config)#radius-server key green 4-104
Console(config)#radius-server retransmit 5 4-105
Console(config)#radius-server timeout 10 4-105
Console(config)#radius-server 1 host 192.168.1.25 4-103
Console(config)#exit
Console#show radius-server
4-106
Remote RADIUS server configuration:
Global settings:
Communication key with RADIUS server: *****
Server port number: 181
Retransmit times: 5
Request timeout: 10
Server 1:
Server IP address: 192.168.1.25
Communication key with RADIUS server: *****
Server port number: 181
Retransmit times: 5
Request timeout: 10
Console#config
Console(config)#authentication login tacacs
4-100
Console(config)#tacacs-server host 10.20.30.40 4-107
Console(config)#tacacs-server port 200 4-108
Console(config)#tacacs-server key green 4-108
Console(config)#exit
Console#show tacacs-server
4-109
Server IP address: 10.20.30.40
Communication key with tacacs server: green
Server port number: 200
Console#