SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 540)

C
OMMAND
L
INE
I
NTERFACE
4-278
DNS Commands
These commands are used to configure Domain Naming System (DNS)
services. You can manually configure entries in the DNS domain name to IP
address mapping table, configure default domain names, or specify one or
more name servers to use for domain name to address translation.
Note that domain name services will not be enabled until at least one name
server is specified with the ip name-server command and domain lookup is
enabled with the ip domain-lookup command.
ip host
This command creates a static entry in the DNS table that maps a host name
to an IP address. Use the no form to remove an entry.
Table 4-70 DNS Commands
Command Function Mode Page
ip host Creates a static host name-to-address
mapping GC 4-278
clear host Deletes entries from the host
name-to-address table PE 4-279
ip domain-name Defines a default domain name for
incomplete host names GC 4-280
ip domain-list Defines a list of default domain names for
incomplete host names GC 4-281
ip name-server Specifies the address of one or more name
servers to use for host name-to-address
translation GC 4-282
ip domain-lookup Enables DNS-based host name-to-address
translation GC 4-283
show hosts Displays the static host name-to-address
mapping table PE 4-284
show dns Displays the configuration for DNS services PE 4-285
show dns cache Displays entries in the DNS cache PE 4-285
clear dns cache Clears all entries from the DNS cache PE 4-286