SMC Networks SMC TigerStack III SMC6824MPE User Manual

Page 347

LASH

ILE

OMMANDS

4-85

Command Usage

• The system prompts for data required to complete the copy command.
• The destination file name should not contain slashes (\ or /), the leading

letter of the file name should not be a period (.), and the maximum length
for file names on the TFTP server is 127 characters or 31 characters for
files on the switch. (Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)

• Due to the size limit of the flash memory, the switch supports only two

operation code files.

• The maximum number of user-defined configuration files depends on

available memory.

• You can use “Factory_Default_Config.cfg” as the source to copy from

the factory default configuration file, but you cannot use it as the
destination.

• To replace the startup configuration, you must use startup-config as the

destination.

• The Boot ROM and Loader cannot be uploaded or downloaded from

the TFTP server. You must follow the instructions in the release notes
for new firmware, or contact your distributor for help.

• For information on specifying an https-certificate, see “Replacing the

Default Secure-site Certificate” on page -67. For information on
configuring the switch to use HTTPS/SSL for a secure connection, see “ip
http secure-server” on page -43.

• When updating the PoE controller, first copy the PD controller file from

a TFTP server to the switch's file system (copy file tftp, and select
“PD_Controller”), and then copy this file to the controller (copy file
controller, and select PoE).

• When specifying the file type “PD_Controller” or “PoE” for copy

operations, file types other than PoE controller may be downloaded, but
will not adversely affect the system.