SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 326)

C
OMMAND
L
INE
I
NTERFACE
4-64
show logging
Use this command to display the logging configuration, along with any
system and event messages stored in memory.
Syntax
show logging {flash | ram | trap}
• flash - Event history stored in flash memory (i.e., permanent
memory).
• ram - Event history stored in temporary RAM (i.e., memory flushed
on power reset).
• trap - Displays settings for logging to remote servers.
Default Setting
None
Command Mode
Privileged Exec
Example
The following example shows that system logging is enabled, the message
level for flash memory is “errors” (i.e., default level 3 - 0), the message level
for RAM is “debugging” (i.e., default level 7 - 0), and lists one sample error
Console#show logging flash
Syslog logging: Enable
History logging in FLASH: level errors
[0] 0:0:5 1/1/1
“PRI_MGR_InitDefault function fails."
level: 3, module: 13, function: 0, and event no.: 0
Console#show logging ram
Syslog logging: Enable
History logging in RAM: level debugging
[0] 0:0:5 1/1/1
"PRI_MGR_InitDefault function fails."
level: 3, module: 13, function: 0, and event no.: 0
Console#