SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 178)

C
ONFIGURING THE
S
WITCH
3-128
Rate limiting can be applied to individual ports or trunks. When an
interface is configured with this feature, the traffic rate will be monitored
by the hardware to verify conformity. Non-conforming traffic is dropped,
conforming traffic is forwarded without any changes.
Command Attribute
Rate Limit – Sets the output rate limit for an interface.
Default Status – Disabled
Default Rate – 100 Mbps
Range – 1 - 1000 Mbps
Web - Click Rate Limit, Input/Output Port/Trunk Configuration. Set the
Input Rate Limit Status or Output Rate Limit Status, then set the rate limit
for the individual interfaces, and click Apply.
Figure 3-57 Rate Limit Configuration
CLI - This example sets the rate limit for input and output traffic passing
through port 1 to 600 Mbps.
Console(config)#interface ethernet 1/1 4-174
Console(config-if)#rate-limit input 600 4-190
Console(config-if)#rate-limit output 600 4-190
Console(config-if)#