SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 510)

C
OMMAND
L
INE
I
NTERFACE
4-248
Default Setting
Weights 1, 4, 16 and 64 are assigned to queue 0, 1, 2 and 3 respectively.
Command Mode
Global Configuration
Command Usage
WRR controls bandwidth sharing at the egress port by defining
scheduling weights.
Example
The following example shows how to assign WRR weights of 1, 3, 5 and 7 to
the CoS priority queues 0, 1, 2 and 3:
Related Commands
show queue bandwidth (4-250)
queue cos-map
Use this command to assign class of service (CoS) values to the priority
queues (i.e., hardware output queues 0 - 3). Use the no form to set the CoS
map to the default values.
Syntax
queue cos-map queue_id [cos1 ... cosn]
no queue cos-map
• queue_id - The ID of the priority queue.
• Ranges are 0 to 3, where 3 is the highest priority queue.
• cos1 .. cosn - The CoS values that are mapped to the queue ID. It is a
space-separated list of numbers. The CoS value is a number from 0 to
7, where 7 is the highest priority.
Console(config)#queue bandwidth 1 3 5 7
Console(config)#