SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 505)

GVRP
AND
B
RIDGE
E
XTENSION
C
OMMANDS
4-243
• Timer values must meet the following restrictions:
- leave >= (2 x join)
- leaveall > leave
Note: Set GVRP timers on all Layer 2 devices connected in the same
network to the same values. Otherwise, GVRP may not operate
successfully.
Example
Related Commands
show garp timer (4-243)
show garp timer
Use this command to show the GARP timers for the selected interface.
Syntax
show garp timer [interface]
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
Default Setting
Shows all GARP timers.
Command Mode
Normal Exec, Privileged Exec
Console(config)#interface ethernet 1/1
Console(config-if)#garp timer join 100
Console(config-if)#