SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 485)

S
PANNING
T
REE
C
OMMANDS
4-223
• This command is the same as spanning-tree edge-port, and is only
included for backward compatibility with earlier products. Note that this
command may be removed for future software versions.
Example
Related Commands
spanning-tree edge-port (4-221)
spanning-tree link-type
Use this command to configure the link type for Rapid Spanning Tree and
Multiple Spanning Tree. Use the no form to restore the default.
Syntax
spanning-tree link-type {auto | point-to-point | shared}
no spanning-tree link-type
• auto - Automatically derived from the duplex mode setting.
• point-to-point - Point-to-point link.
• shared - Shared medium.
Default Setting
auto
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Specify a point-to-point link if the interface can only be connected to
exactly one other bridge, or a shared link if it can be connected to two or
more bridges.
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree portfast
Console(config-if)#