SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 444)

C
OMMAND
L
INE
I
NTERFACE
4-182
Example
The following shows how to configure broadcast storm control at 600
packets per second on port 5.
clear counters
Use this command to clear statistics on an interface.
Syntax
clear counters interface
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Statistics are only initialized for a power reset. This command sets the
base value for displayed statistics to zero for the current management
session. However, if you log out and back into the management interface,
the statistics displayed will show the absolute value accumulated since the
last power reset.
Example
The following example clears statistics on Ethernet port 1/1.
Console(config)#interface ethernet 1/5
Console(config-if)#switchport broadcast packet-rate 600
Console(config-if)#
Console#clear counters ethernet 1/1
Console#