Port configuration, Displaying connection status, Port configuration -104 – SMC Networks SMC TigerStack III SMC6824MPE User Manual
Page 154: Displaying connection status -104
C
ONFIGURING
THE
S
WITCH
3-104
CLI – This example assigns an IP and MAC ingress ACL to port 1, and an
IP ingress ACL to port 2.
Port Configuration
Displaying Connection Status
You can use the Port Information or Trunk Information pages to display
the current connection status, including link state, speed/duplex mode,
flow control, and auto-negotiation.
Command Attributes (Web)
•
Name – Interface label.
•
Type – Indicates the port type (10BASE-T, 100BASE-TX,
1000BASE-T, 1000BASE-SFP).
•
Admin Status – Shows if the interface is enabled or disabled.
•
Oper Status – Indicates if the link is Up or Down.
•
Speed Duplex Status – Shows the current speed and duplex mode.
(Auto, or fixed choice)
•
Flow Control Status – Indicates the type of flow control currently in
use. (IEEE 802.3x, Back-Pressure or None)
•
Autonegotiation – Shows if auto-negotiation is enabled or disabled.
•
Trunk Member – Shows if port is a trunk member.
(Port Information only.)
•
Creation – Shows if a trunk is manually configured.
(Trunk Information only.).
Console(config)#interface ethernet 1/1
Console(config-if)#ip access-group david in
Console(config-if)#mac access-group jerry in
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#ip access-group david in
Console(config-if)#