SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 527)

M
ULTICAST
F
ILTERING
C
OMMANDS
4-265
Example
The following shows the multicast entries learned through IGMP snooping
for VLAN 1:
IGMP Query Commands (Layer 2)
ip igmp snooping querier
Use this command to enable the switch as an IGMP querier. Use the no
form to disable it.
Syntax
[no] ip igmp snooping querier
Default Setting
Enabled
Command Mode
Console#show mac-address-table multicast vlan 1 igmp-snooping
VLAN M'cast IP addr. Member ports Type
---- --------------- ------------ -------
1 224.1.2.3 Eth1/11 IGMP
Console#
Table 4-67 IGMP Query Commands (Layer 2)
Command Function Mode Page
ip igmp snooping querier Allows this device to act as the querier
for IGMP snooping
GC 4-265
ip igmp snooping
query-count Configures the query count GC 4-266
ip igmp snooping
query-interval Configures the query interval GC 4-267
ip igmp snooping
query-max-response-time Configures the report delay GC 4-268
ip igmp snooping
router-port-expire-time Configures the query timeout GC 4-269