SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 504)

C
OMMAND
L
INE
I
NTERFACE
4-242
Example
garp timer
Use this command to set the values for the join, leave and leaveall timers. Use
the no form to restore the timers' default values.
Syntax
garp timer {join | leave | leaveall} timer_value
no garp timer {join | leave | leaveall}
• {join | leave | leaveall} - Which timer to set.
• timer_value - Value of timer.
Ranges:
- join: 20-1000 centiseconds
- leave: 60-3000 centiseconds
- leavall: 500-18000 centiseconds
Default Setting
• join: 20 centiseconds
• leave: 60 centiseconds
• leaveall: 1000 centiseconds
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Group Address Registration Protocol is used by GVRP and GMRP to
register or deregister client attributes for client services within a bridged
LAN. The default values for the GARP timers are independent of the
media access method or data rate. These values should not be changed
unless you are experiencing difficulties with GMRP or GVRP
registration/deregistration.
• Timer values are applied to GVRP for all the ports on all VLANs.
Console#show gvrp configuration ethernet 1/7
Eth 1/ 7:
Gvrp configuration: Disabled
Console#