SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 534)

C
OMMAND
L
INE
I
NTERFACE
4-272
IP Interface Commands
There are no IP addresses assigned to this switch by default. You must
manually configure a new address to manage the switch over your network.
You may also need to a establish a default gateway between this device and
the management stations.
ip address
Use this command to set the IP address for the currently selected VLAN
interface. Use the no form to restore the default IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp}
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
• bootp - Obtains IP address from BOOTP.
• dhcp - Obtains IP address from DHCP.
Table 4-69 IP Interface Command Syntax
Command Function Mode Page
ip address Sets the IP address for the current interface IC 4-272
ip
default-gateway Defines the default gateway through which an
in-band management station can reach this
device GC 4-274
ip dhcp restart Submits a BOOTP or DCHP client request PE 4-275
show ip interface Displays the IP settings for this device PE 4-275
show ip redirects Displays the default gateway configured for this
device
PE 4-276
ping Sends ICMP echo request packets to another
node on the network NE,
PE 4-276